Did you remember to calibrate your sticks after flashing your Devo?

Denovich said:

Did you remember to calibrate the sticks after you flashed your Devo?

Every time you flash you need to repeat that.

2) Transmitter Menu
1) Transmitter Config
Select Calibrate, hit ENT
Follow directions on screen.

Use Devo.

Adafruit ftw!

Documentation and Tutorials
1 Watt Cool White LED – Heatsink Mounted
 Tutorials: [[http://www.adafruit.com/products/518#tutorials]]
Adafruit LED Sequins – Royal Blue – Pack of 5
 Tutorials: [[http://www.adafruit.com/products/1757#tutorials]]
Adafruit LED Sequins – Ruby Red – Pack of 5
 Tutorials: [[http://www.adafruit.com/products/1755#tutorials]]
Adafruit LED Sequins – Emerald Green – Pack of 5
 Tutorials: [[http://www.adafruit.com/products/1756#tutorials]]
SMT Cool White 5050 LED – 10 pack
 Tutorials: [[http://www.adafruit.com/products/682#tutorials]]
Adafruit LED Sequins – Warm White – Pack of 5
 Tutorials: [[http://www.adafruit.com/products/1758#tutorials]]

OrangeRx R614XN DSM2/DSMX


Manual: https://hobbyking.com/media/file/o/r/orangerxr614xn.pdf

Eachine F4 Brushed FCB


Great info here: https://forum.dronin.org/forum/d/200-eachine-f4-brushed-flight-controler/7

dRonin tune: https://dronin-autotown.appspot.com/at/tune/ahFzfmRyb25pbi1hdXRvdG93bnIYCxILVHVuZVJlc3VsdHMYgICA4Ky5hQsM

…and I’m only now understanding that dRonin is another configurator: http://dronin.org/

Micro 32bits F3 Brushed FCB

Product: http://www.banggood.com/Micro-32bits-Brushed-Flight-Control-Board-Based-On-SP-RACING-F3-EVO-Brush-For-Micro-FPV-Frame-p-1070068.html

Manual: http://img.banggood.com/file/products/20160816214511F3_EVO_Brush%20manual%E8%8B%B1%E6%96%87%E7%89%88%E8%AF%B4%E6%98%8E%E4%B9%A6.pdf

Bootpins: http://forum.banggood.com/forum-topic-234156.html

Binding is between your receiver, not your FCB, and your transmitter!

I was struggling with getting my quad bound to my new Devo 7e (flashed with Deviation), and it’s because I had thought I was trying to bind via DSMX from my F3_EVO_Brush board. Duh, the FCB didn’t even have its own receiver! I had soldered a Das Mikro Rx, but hidden it under the camera’s foam case.

Looking at the Das Mikro, it only did DSM2, so setting spektrum_sat_bind=9 wasn’t ever going to work; I had to set spektrum_sat_bind=7!

Also, the Das Mikro only did PPM, so setting the Receiver tab of CleanFlight to RX_Serial wasn’t ever going to work either!

Learning the hard way, that’s my lot in life. Got it down, though, and things are progressing!