Micro Scisky 32bits Brushed Flight Control Board Built-in Frsky SFHSS Compatible RX for Quadcopters
Note: This new version with built-in FrSky compatible receiver and Futaba SFHSS compatible receiver gets the same appearance as that of DSMX/DSM2 compatible one on one side of the board. The only difference is the hardware for receiver on the other side of the board.
Size: 20.0*33.5*6.0mm (not including the USB protruding part)
Version: Frsky version and SFHSS Version Optional
(including Frsky compatible 7CH receiver by serial port output )
Integrated with DCDC voltage booster circuit( output 5.0V/500Ma), it can supply power for other device through IIC and UART port
Integrated with DCDC voltage booster circuit( output 5.0V/500Ma), it can supply power for other device through IIC and UART port;
something like 5cm will be better. No binding button on the board.
For firmware flash:
If there is a mistake happened when the firmware was flashing.
Please soldering the cable like the following:
please flash firmware by Flash Loader Demo, after that, please remove the soldered cable.
Then you can flash the latest firmware or other version firmware through Cleanflight GUI.
About the integrated receiver setting:
Receiver Mode: Pls do choose RX_PPM
How to set up brushed ESC mode after the firmware is flashed:
-Set MOTOR_PWM_RATE parameter >2000 but<32000, the details are the following:
-Under CLI order enters “set motor_pwm_rate=2000”, then click “enter”, then input ”save” and click “enter” again.
So you can set our 32 FC to brushed ESC mode after the firmware is flashed
(note:2000 means the signal frequency for controlling the brushed motor is 2KHz, the maximum you can set is 32000, that is 32KHz)
The following parts are suitable for this flight control board: (not included)
1 x 32bits Brushed Flight Control Board